Vertical Xcelerator IP Specifikace Strana 61

  • Stažení
  • Přidat do mých příruček
  • Tisk
  • Strana
    / 120
  • Tabulka s obsahem
  • KNIHY
  • Hodnocené. / 5. Na základě hodnocení zákazníků
Zobrazit stránku 60
Advanced Settings 5-9
Chapter 5 - Xcelerator IP Configuration
Xcelerator IP Administrator Manual March 2007
Route
The Routing options are separated into two parts: Static Route and RIP (Routing
Information Protocol).
Static Route (Add)
- On the Routing page, click on the ADD button to create a new Static Route.
- Enter the destination network address, subnet mask, gateway AND/OR available
WAN interface, then click "Save Settings" to add the entry to the routing table.
- A maximum of 32 entries may be configured.
RIP
- To activate RIP for a device, select the "Enabled" radio button for Global RIP Mode.
- To configure an individual interface (br0 or eth0), select the desired RIP version
(1, 2 or Both) and the mode of operation (Active or Passive), then click the
"Enabled" checkbox for the desired interface.
- Click the "Save Settings" button to save the configuration and to start or stop RIP
based on the Global RIP mode selected.
Zobrazit stránku 60
1 2 ... 56 57 58 59 60 61 62 63 64 65 66 ... 119 120

Komentáře k této Příručce

Žádné komentáře